55
edits
Changes
Jump to navigation
Jump to search
Line 53:
Line 53: +
→Starting the Laser Cutter
===Clean Up and Turning Off the Laser===
===Clean Up and Turning Off the Laser===
[[File:LaserButtons.png|200px|thumb|right|Buttons]]
#Clean up the laser cutting area with a vacuum if your design had lots of little pieces that could fall into and through the honeycomb.
#Clean up the laser cutting area with a vacuum if your design had lots of little pieces that could fall into and through the honeycomb.
#To turn off the laser cutter, exit the software and press the “stop” button to turn off the machine. A red button will flash while the bulb cools. Note: do not hold down the stop button when you turn off the machine.
#To turn off the laser cutter, exit the software and press the “stop” button to turn off the machine. A red button will flash while the bulb cools. Note: do not hold down the stop button when you turn off the machine.